• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

power loss in water only

Status
Not open for further replies.

kreug5

New Member
had my 2001 xp flip on my wife abd whole back end filled full of water.I towed in and pulled plugs to release all water theni put back in lake. Seadoo ran fine for HALF HOUR.Then the sedoo just went from 7 rpms to 4.5 while traveling down the lake.i pulled sedoo out and tested gas and also added heetpwc additive and the it didnt work, checked fuel and it looked clear and clean.pulled fuel filter and it looked ok also. spark plugs looked visually ok. the seadoo runs normally when i hook hose up and run it out of water but once it gets in lake it does go but a consistant 4.5.it was just odd how it was flooded a half hour earlier and ran fine after emtying water out for a good period and then it just loss power. and help would be apreciated. brett
 
Did you tip the Seadoo the correct way to get the water out of the exhaust
system as well? Water tends to dry up oil...so even if you blew the water from the plugs there still would be so rezid water chillin in their.
I forgot the name of the product (fast search on here would reveile)
That you pour into it after you had some water in it.

Could be fine after that..
 
Status
Not open for further replies.
Back
Top