• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

No water through pisser at low speed and both engines cut out. 1997 Speedster

Status
Not open for further replies.

Chips

New Member
I am working though some issues on my Speedster but have a questions about the water pisser. When I am idling through no wake zone, there isn't any water coming from pisser and if I idle long enough both engines will just cut out and die.

There are no warning beeps for overheating but it "seems" like the system is shutting things down due to this.

The only other thing I can think of, is when this has happened more often then not, I have the engine compartment fan on...
 
Mine doesnt have a lot of water coming out at idle either, think its normal. 2 strokes dont like to idle for extended periods of time anyway, if im going thru a long no wake area i usually shut down one engine then can throttle the other higher so it doesnt load up.
 
Mine doesnt have a lot of water coming out at idle either, think its normal. 2 strokes dont like to idle for extended periods of time anyway, if im going thru a long no wake area i usually shut down one engine then can throttle the other higher so it doesnt load up.

yea but he says NO water coming out, there should at least be a small stream. I think he needs to start by checking the cooling hoses for any clogs.
 
Flushing the hoses is pretty easy, at least on my 95 speedster. The shop manual has a pretty easy to follow section on it. Try that and make sure you have water flowing.
 
Status
Not open for further replies.
Back
Top