Liamjoseph2
Member
Hello, Last summer in September I was going to take my ski out of the water for the year (I have it on a ramp for the summer), and the battery was dead. I used a high power lithium-ion jump pack on it and it started for about 30 seconds then shut off and never turned back on.
Upon inspection the 15 amp fuse blew so I replaced it to no avail. I stored it for the winter and started working on it again this summer. I assumed it was the MPEM so I bought an aftermarket unit from Arieltek, but the quality was so bad I couldn't even fit the connectors in due to how bent they where and it was also covered in glue, so I sent it back.
Due to the fact that the used MPEMs on eBay come with no returns and no warranty, I wanted to troubleshoot that the issue is in fact the MPEM. I tested the red/purple? wire for power on the MPEM connector and was getting an oscillating 0.5v where I would have expected 12v so that is a little concerning.
Any tips for what I should do / try next? Should I just buy the new MPEM?
All help is extremely appreciated, Thank you!
Upon inspection the 15 amp fuse blew so I replaced it to no avail. I stored it for the winter and started working on it again this summer. I assumed it was the MPEM so I bought an aftermarket unit from Arieltek, but the quality was so bad I couldn't even fit the connectors in due to how bent they where and it was also covered in glue, so I sent it back.
Due to the fact that the used MPEMs on eBay come with no returns and no warranty, I wanted to troubleshoot that the issue is in fact the MPEM. I tested the red/purple? wire for power on the MPEM connector and was getting an oscillating 0.5v where I would have expected 12v so that is a little concerning.
Any tips for what I should do / try next? Should I just buy the new MPEM?
All help is extremely appreciated, Thank you!