Jet pump rebuild

[Uncle_Tone]

My impeller shaft seized up last ride of the year so now since everyone has nothing to do....this is my project to get ready for the summer. I ordered the rebuild kit from SBT and I have 3 leftover parts, all o-rings. The one bigger one which I'm assuming is the o ring for the cone and 2 smaller ones, small and thin. Where do these go?? Ski is a 2001 RXDI and I don't see any 2 o rings on the diagram. I don't want to leave them out so it comes back bites me in the ass.......

 

[emspjay]

They are for the bilge drain line things on the pump housing #35 in the parts diagram.

 

[Uncle_Tone]

They are for the bilge drain line things on the pump housing #35 in the parts diagram.

Sounds good, I'll check swap them out today. I was concerned only because on the impeller shaft there is a groove up by the thrust washer and bearing that looks like some small o ring would actually fit there. I actually tried that but the ring is too small to fit over the threads and slide down the shaft.