hey do you guys know how to get the feul to pass thur the lines ...because i have just rebuilt a seadoo sp and i need to get the feul to pass thur the lines to the carb. do i just keep turning it over to get the feul to pump thur????not sure but please if you know what to do please can you help me out?
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
feul lines???
- Thread starter SP RACER
- Start date
- Status
Fuel?
That's all I would think you need to do. Pull the choke out and spin the engine over for no longer than 30 seconds. Let the engine sit a few minutes, then try again.
After trying this a couple times, feel your battery wires. If there warm to hot, let it cool off. Means your heating your starter up. Check the inline fuel filter, has fuel got to it yet?
By closing the choke on the carbs, your reducing the air flow, creating a vacuum in the carbs, should help in bringing fuel through your lines.
Let me know if any of this works!:hat:
That's all I would think you need to do. Pull the choke out and spin the engine over for no longer than 30 seconds. Let the engine sit a few minutes, then try again.
After trying this a couple times, feel your battery wires. If there warm to hot, let it cool off. Means your heating your starter up. Check the inline fuel filter, has fuel got to it yet?
By closing the choke on the carbs, your reducing the air flow, creating a vacuum in the carbs, should help in bringing fuel through your lines.
Let me know if any of this works!:hat:
thanks man !!!! i will deff try that .... i tell you if it works
- Status
