Hey guys, I am getting my jetski ready to put in the water. It’s a 2005 sea food gtx limited. I did an oil change and added coolant and put in last years battery. I took it out on the water it started then died right after. I tried to start it again and it wouldn’t turn over unless i held full throttle. I got code p0562. I found that it was low voltage and put in a new battery but the same thing kept happening. Any thought or idea on how to fix it? Thanks I’m advance.
-
This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.
Code p0562
- Thread starter Nick10
- Start date
- Status
Mr@RXT
Member
I don’t know but is your battery charging if you put a new battery in and it worked than tried starting it again sounds like a charging issue but not really sure
Mr@RXT
Member
The new battery is in right and your still getting the 12 V low? Where did you get the battery
I bought it from auto zone. It is a duralast gold, the directions say no need to charge it. I tested it with a multimeter, which said 12.7 volts, and when running, it was around mid-11s. I looked into reviews on the battery, and many of them still said that I needed to charge it before use. So I charged it for a couple of hours and put it back in. I ran it and the idle problem seemed to be gone and the engine seemed to sound a lot better. The problem now is it blinks sensor 3 times and the code still shows up. I was in a hurry and didn't see what the voltage was after the charge. I will do that tomorrow.
sktn77a
Active Member
Yeah, right. Charge it up and replace the plugs.
12.7v out of ski is in the ballpark, however SkiAsylum s correct, 11v running in the ski is way too low. Inorder for the ski to keep the battery charged it has to supply a higher voltage, 13.5 is also in the ball park. Your on board charging is not working correctly. Check your car, same idea.
- Status
