red2blue
New Member
...first time in almost two years.
I installed the rad4racing torque plate last week....was woried about the added length of j-pipe in my oem water box. So, I pulled it and shortened it an inch. Now....I ran it last week and only saw 7900 or so with brief flashes of 8000. Did have lousy weather...t-storms, wind ect, very choppy conditions.
Okay...in optimal conditions used to run 7950 in the heat. With low fuel I'd get a top speed of 72.7 @ 8050. Today...woohoo...in light chop-ripples full tank of gas....E86, L69...steadily pulled up and topped out at 71.7 @ 8100 before I ran outa water....experienced my first real cavitation outa the hole.
Not too shabby If I do say so myself.
I'll leave things as they are till next week...expecting warmer weather so will see if I'm still on the limiter or not....will decide then to re-try my 15/20....or not.
flushed Riva grate, 2* wedge, skegs, diy free-flow exhaust, diy rear air, S3SC, 14/19+2
I installed the rad4racing torque plate last week....was woried about the added length of j-pipe in my oem water box. So, I pulled it and shortened it an inch. Now....I ran it last week and only saw 7900 or so with brief flashes of 8000. Did have lousy weather...t-storms, wind ect, very choppy conditions.
Okay...in optimal conditions used to run 7950 in the heat. With low fuel I'd get a top speed of 72.7 @ 8050. Today...woohoo...in light chop-ripples full tank of gas....E86, L69...steadily pulled up and topped out at 71.7 @ 8100 before I ran outa water....experienced my first real cavitation outa the hole.
Not too shabby If I do say so myself.
I'll leave things as they are till next week...expecting warmer weather so will see if I'm still on the limiter or not....will decide then to re-try my 15/20....or not.
flushed Riva grate, 2* wedge, skegs, diy free-flow exhaust, diy rear air, S3SC, 14/19+2
