• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

96 SeaDoo blowing the Main Fuse

Status
Not open for further replies.

TheCabralFamily

Active Member
Good Morning...

I'm looking for some information to help my brother in law with his 96 Seadoo. It was a chain reaction type of event.

Wear Ring went out while riding, picked up a ton of weeds and in the process cracked the exhaust pipe just above the manifold. (Assume from over heating) This in turn caused a large amount of water to fill the hull. We were able to restore the exhaust system, but trying to start it, the main 5 amp fuse blows. The engine will turn over for 2-3 seconds then the whole system shuts down when the fuse blows again. We have dried out every connection we can find, as well as had a fan running thru it in the south Florida sun to dry out the hull.

Any suggestions on why the fuse keeps blowing? Thank You

Tim
 
Double check the rear e-box. Also if it's still blowing try unhooking the plug for the VTS (I'm assuming you have VTS, but we need to know the model of ski). If there is water in the VTS motor it will blow fuses and can even fry the MPEM.
 
Status
Not open for further replies.
Back
Top