'96 GSX Part Out

[TLH101]

Parting a '96 GSX
I have the complete ski, and all parts are for sale.
The impeller, wear ring, voltage regulator, and VTS module are all bad. The VTS motor has been tested and works good, both directions. The pump housing has a couple of minor nicks on the vanes, and the thrust bearing is bad. Shaft and shaft bearings are good. This has the combined MPEM module, and a dees key, however the key is very deteriorated, and would only be good to run the ski. It will not hold tight to the dess post. The rest of the ski appears to be operational. The seat, and hood look rough and hull is solid but needs elbow grease.
A video can be seen here: https://www.youtube.com/watch?v=LUSxGpgs-fc
Here's a few pics:

 

[nickj718]

How much for the sponsons

 

[TLH101]

How much for the sponsons

How about $100 plus the shipping cost?

 

[TLH101]

Oil tank, and rear trim corners sold.
Rest of the parts will be going to ebay soon.

 

[TLH101]

Mpem, info center, & sponsons sold.

 

[philipl]

Rave valves? Water regulator?

 

[TLH101]

Rave valves are still on the motor, and water valve still on the water box. Let me pull them tomorrow, and make sure they are all OK.

 

[TLH101]

Here's pics of the rave valves. They will need O-rings as both leak oil.

 

[TLH101]

Here is the water valve. I has the lower bellows clamp rusted away, and 2 nicks in the bellows that do not go thru the bellows. May need a rebuild.