• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

96 Challenger 780 where should water be coming out?

Status
Not open for further replies.

Yooper Dooer

New Member
Greetings friends! I had my Challenger out of the water and connected to the upper washout port with the engine running. I was wondering which places shout have water coming out - what I have noticed so far is the exhaust, the pisser, and the rear washout port and nothing from the nylon port next to the rear washout port- is this right???? Should water be coming out of the rear nylon port next to the rear washout port? Should the rear and upper washout ports be plugged when the engine is in normal use? Please friends!!! I just want to make sure water is getting to where it should...
 
According to the manual you should connect your hose to the rear washout port. But you can use the upper one if you install a hose pincher on the rear washout.

Remember to not run flush longer than 5min. the drive line seals are not in the water and can over heat.

To answer your question... Water comes out only two places (exhaust and pisser.. rear washout should be pinched off)
The nylon port next to the rear washout is your bilge pump port... So NO WATER will come from this during a flush unless you have a leak in your cooling system and the interior of the boat is getting flooded.
 
Status
Not open for further replies.
Back
Top