• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

94 xp carb reassemble help

Jakeo625

Member
Long story short I bought a "running 1994 seadoo xp 657x jetski 3 years ago went to get it on the lake would run on the trailer not in the water had a dead cylinder sat for a year himming and hawing on what to do with it last year old got a hold of ses and got a rebuilt engine another story in and of itself but none the less got the engine started disassembling last summer and now I'm finally putting it back together I took quite a few picture but for the life of me didn't take ones I needed for the carb

1st theres no choke plates etc all the manuals show a choke is this normal?

2nd on one side of where choke rod should go is a small ripple what connects to this?

3rd where choke goes it goes nipple one side brass plug next carb brass plug then empty hole i didnt take pictures of what was in the hole whether it be a plug or nipple can someone let me know

4th in the manuals it shows a second cable bracket which previous owner must have removed became i have pictures of that area and said bracket isn't there is it necessary?

5th I have a brass tee I don't recall where it ties in at but it was with carb stuff so I assume it belongs

If someone has detailed photos of the carb assembly from a 1994 seadoo xp with cable and fuel routing and could share with me i would be eternally grateful
 

Attachments

  • 20260222_153528.jpg
    20260222_153528.jpg
    443 KB · Views: 0
  • 20260222_153539.jpg
    20260222_153539.jpg
    777 KB · Views: 0
  • 20260222_153543.jpg
    20260222_153543.jpg
    485.6 KB · Views: 0
  • 20260222_153545.jpg
    20260222_153545.jpg
    525.9 KB · Views: 0
  • 20260222_153548.jpg
    20260222_153548.jpg
    504.4 KB · Views: 0
  • 20260222_153555.jpg
    20260222_153555.jpg
    381.3 KB · Views: 0
  • 20260222_153522.jpg
    20260222_153522.jpg
    381.9 KB · Views: 0
  • 20260222_153513.jpg
    20260222_153513.jpg
    774.1 KB · Views: 0
Back
Top