• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

2007 Wake Edition won't start

Status
Not open for further replies.

BIYAAAAAAW

New Member
My 2007 Wake won't start. I have swapped out the starter solenoid and it is good. When I "jump" the solenoid, I hear something turning (sounds like the starter turning maybe) but there is no ignition or spark at the solenoid (I have an identical one that sparks and starts up when I do this). I also have a fault code of P 1502. Any suggestions on what my problem may be?
 
Your T.O.P.S sensor , tip over protection sensor or the wiring to it are faulty. Look in the parts at the top of the page to find your model and the description is in the electrical gauge/console assembly.
 
Your T.O.P.S sensor , tip over protection sensor or the wiring to it are faulty. Look in the parts at the top of the page to find your model and the description is in the electrical gauge/console assembly.
I looked in the parts section in the electrical gauage/console assembly and cant seem to find it for the life of me. Do you have a link?
 
Some are on the side of the fuse box, mine is newer and it's under the engine crankcase vent. Keep looking it's there somewhere. The code you show is the TOPS sensor faulty.
 
Status
Not open for further replies.
Back
Top