Czvas
Member
Hey everyone, I have a 2004 GTI 717 and I’m looking to make sure the high and low are set properly. The carb has these brass looking caps so I can’t get to the low and high. Are they under these caps and then able to adjust with a flat head? How do you remove the caps?
My problem is it has no balls at the get go
But then seems like it breaks through and runs great.
Work done so far:
Compression 140psi+ both cylinders
Fuel baffle new magnet (gas gauge)
Carb has been rebuilt
Needle and seat have been replaced 2.0
Pop off is in spec 36-40 psi
New fuel water separator filter
Sonic cleaned the fuel selector valve
Replaced the gas lines
Complete jet pump housing rebuild/oil/bearings seals/ wear ring
Carbon seal and ring replaced
New plugs/new ngk wire caps
thank guys in advance!
My problem is it has no balls at the get go
But then seems like it breaks through and runs great.
Work done so far:
Compression 140psi+ both cylinders
Fuel baffle new magnet (gas gauge)
Carb has been rebuilt
Needle and seat have been replaced 2.0
Pop off is in spec 36-40 psi
New fuel water separator filter
Sonic cleaned the fuel selector valve
Replaced the gas lines
Complete jet pump housing rebuild/oil/bearings seals/ wear ring
Carbon seal and ring replaced
New plugs/new ngk wire caps
thank guys in advance!