2001 rxx build

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.
Oh I meant to give you a tip on assembly of the twins. Clean the shit out of the flanges where the 3 orings go. Install the new orings (factory pipe recommended new orings every time the pipes are disassembled) spray windex on the flanges of the two header pipes and the will snap together fairly easily. They have to go straight in not at an angle or you may move one of the orings off its seat and end up with an exhaust leak.
 
Oh I meant to give you a tip on assembly of the twins. Clean the shit out of the flanges where the 3 orings go. Install the new orings (factory pipe recommended new orings every time the pipes are disassembled) spray windex on the flanges of the two header pipes and the will snap together fairly easily. They have to go straight in not at an angle or you may move one of the orings off its seat and end up with an exhaust leak.
Where did you install your egts? Do you have a pic?
 
There is one spot on each header you will miss the water Jacket
191cab3cdcb9e371d1244fc5f1ca9a72.jpg
817a8aa44ca97bf10d4630a7d7e6c0a1.jpg
 
In the pic I put green tape on where I think I should put the egt. I know I'm not drilling on the bottom but on the side...just easy to take the pic like this....thoughts 1 of 500
138c5c6c87da840cdb8bc86ef686c5b2.jpg
 
Well I put the motor in the ski tonight. I will work on alignment tomorrow. I pulled the pump off tonight. Thoughts? One of the bolts that holds the nozzle on ended up pulling the Helicoil out the scat pump. Have you guys ever seen this?
dcb04e0370d9a388dbc5149ab0c0a3bb.jpg
0cf8620490ab35df9d27f41d52f10cf7.jpg
0e79ede4b9b4c272aa158bb4cd099603.jpg
 
They sell repair Helicoils that are for fixing stripped ones like that, they are a little bigger. You could also call Glen at Skat-Trak.
 
Ok got the right Helicoil tonight. Its an M8 by 1.25. Pulled apart the scat pump everything looks to be good. Just going to do an oil change. Is it okay to run this type of oil just like in any other Seadoo pump? I also got the motor aligned, just need to tighten down the bolts. I picked up a Brand new Ultrasonic Cleaner ,so the carbs will go in that tomorrow. I really look to finish the ski up this weekend as far motor work goes. I about forgot, I just got me a new cover as well.


I'm getting closer on the graphics with Mike from PwC graphics as well.
6b441c7cf304ab2d0acef4c9a5520d5d.jpg
60e201e46139cad2d5055e03038fb525.jpg
94f763b2766939d0ec65a353371595f9.jpg
3cab069d9239072de9c7ffd16664689a.jpg
53926858f796174129274ba7498da6cf.jpg
520dd09c15485b3cfc6b69a0063f49b7.jpg
 
Last edited:
If you are on tapatalk just click on your post anywhere to highlight it, then click edit.

Edit: I just thought you were drunk, lol.
 
Status
Not open for further replies.
Back
Top