• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

1995 Speedster twin 650 boat PARTING OUT!! CHECK IT OUT!

Status
Not open for further replies.
I have already sold several parts thanks to a few people, here are some parts that I think would interest people of what I have left. Also if I am not listing something you want just check with me I may have the part you need. These parts Im listing below I will put up on ebay if I dont get any interests here. I dont mind taking pictures of parts if you want also. All these parts are mostly hard to find if not impossible because they are no longer made.

1. Complete Electrical box (without MPEM everything else is there in perfect condition)Everything is there all wires EVERYTHING.

2. Complete Wire Harness that plugs into the MPEM and runs to the front storage area.

3. Both Throttle Cables (good working condition)

4. Both Choke Cables (good working condition)

5. Complete Throttle Controller with Plate Cover (good condition)

6. Rear Engine storage cover (w/ light bar if needed)

7. Both light bar and front light

8. Driver side reverse gate (w/ housing plate)

Like I said I have more parts I have both engines with parts on them stator's, carbs, oil pumps, both drive shafts, oil tank (w/sensor), fuel tank (w/ sensor). Send me a message or give me an email. Thanks everyone.
 
I have both engines they need rebuilding when last checked they have low compression and have been sitting now for a little while so. But I am willing to talk and make a deal on whatever you need. Unless you were looking for to solid great running motors I dont think I have what you want but either way just send me a message we can talk I can take some things apart if you want and show you some pictures I do have one engine pretty much ready to pull the other is very close.
 
Ya, I was really looking for good running engines. I could rebuild mine but after roughly figureing what it would cost between parts and machine work it would'nt be much less than SBT drop-in's so I was hoping I could find some good used ones for around $600-900. for the pair.
 
Wireing and mpem

Yes this one has or had the MPEM. I have everything as far as wireing and the electrical box just no MPEM I have sold it already. Not sure if you still interested with that news. However if you are it is all in very good shape. Thanks
 
Intake manifolds

Hi, Jim here.
Would you be willing to part out the intake manifolds with carbs ,oil pumps on them ?
 
Do you still by chance have the throttle controls? Will it fit a 96 speedster? If yes are they in good condition with, screws and connectors all in good shape? Pictures maybe? Thank you...
 
I need a new steering cover. Mine fell apart when I removed to paint. Foam underneath is ok just the cover needed. Do you have one and how much?
 
Looking for two cable levers (attach the cable to the reverse gates); front storage tray/bin; a couple of the sacrificial anodes and screws; engine access cover (storage tray).
 
Status
Not open for further replies.
Back
Top