• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

1990 seadoo sp

Status
Not open for further replies.

lilpain

New Member
my sp only runs up to 5 mph but it raves up all the way just replace the top end ,do i need to mesure the squish .
 
First... this is the boat section.

Second... if it's reving, and not going... I would check the splines in the PTO, and make sure the impeller is actually spinning. If it is... then look for air leaks. (Driveshaft seal, around the pump, and the shoe)
 
Tank Dr Honda it had a dam rope stuck on the drive shaft .I'm going to test it on the week end I will post a update.
 
Status
Not open for further replies.
Back
Top