Recent content by SDSeadooer

No as I remember he was was sitting, and it was just a mild bump of the throttle.

My son ( 30, 200lbs. ) was driving. just sitting in the water waiting to trailer it. When I got the trailer in the water I watched as he gave the ski a little gas and the nose seemed to dig into the water and came over the bow, up high enough to flow over the gas cap, so it just seem front...

GTS seems to be riding very low in the water. Engine compartment stays dry. What is the best way to find out if there is a water leak in the hull below the inside compartment? If there is, what is the best way to remove it? Thru the engine compartment? thanks for any and all your help.

Thanks, I just cleaned the fuel pulse side, and filter of the Mag carb ( As stated above ). I'll do them both. Thanks again for helping me understand the system.

I seem to have gotten all the water out of the tank , lines and carbs and changed the fuel filter. Still won't start, cylinders are dry. it fires right up and runs with primer pump knob and Gas system pressurizes. I removed the gas line to fill a bottle to make 40/1 mix for priming and I'm not...

Long story short, 1995 GTS ( w/2 carbs. ) was ridden in the bay with the gas cap loose and got a bunch of saltwater in the tank. It was a couple of weeks before we realized it when it would not start. we've drained the tank and the filter blew out the cylinders , and it fires right up with...

I just purchased the above seadoo and rebuilt the carbs I have 3 questions about making the carb. adjustments 1 Since there are 2 carbs should I start out with the slow speed screws a little leaner then the recommended 1 1/4 turns out? 2. is there a correct procedure Like slowly leaning...

Thanks, Lou

Can anyone tell me when to know that your rave valves needs adjusting and how to do it?

Rave valve adjustment Can anyone tell me when to know that your rave valve needs adjusting and how to do it?

I have a 96 xp and after I took the cap off, I could not get the center nut ( plastic ) to break free so I could remove the bottom of the top cap off first, before I pulled the valve out. I cant get the front valve out with the cap still on because the exhaust manifold and tune pipe is in the...