Recent content by ID62

  1. ID62

    230 Wake Engine / RPM issues

    Check your injectors, had the same issue in June. Lost RPMs on one engine, but it was fine after cleaning.
  2. ID62

    2007 Seadoo gti 155SE intermittent hard start

    You can clean it, it's a very easy job. It's god to have always a cleaned injector with you when you are in vacation.
  3. ID62

    2007 challenger 180 wants to start but ?

    The rattling outside the water happens due to the design of the Seadoo jet-pump. The impeller sits on his bearing and the drive-shaft is in between of the impeller and the engine. The drive-shaft has a spline on both ends and isn't fixed neither to the engine nor the impeller. Actually it's a...
  4. ID62

    2007 challenger 180 wants to start but ?

    Hi Sofla, It seems you don't get fuel. Why? Ignition seems to be working because it was running with the starting fluid. If you don't smell the fuel after so many times cranking, then there isn't any fuel. So you have to check if your fuel pump delivers the fuel. Perhaps the fuel pump isn't...
  5. ID62

    Tachometer replacement for Utopia 205 w. Rotax 1503

    Hello all, Just changed my tachometers on a 2006 UTOPIA 205 with the 1503 Rotax engines. For those who would like to replace their tachometers, I bought them from FARIA. They are up to 7000 rpm (the N/A engines goes just to 7300 max.) which is enough for the 1503 N/A. The signal sent to the...
  6. ID62

    Speedster 200 intake grates stuck

    make a modification .... see my one in YTube
  7. ID62

    4-tec Challenger REstart problem

    I had equal issues with one engine. It was a leaking injector which created the problem. I changed them all and the engine started fine again. The injectors are from BOSCH and I paid roughly 40 Euros for one piece. If you purchase these from the Seadoo dealer it costs much more. Check out the...
  8. ID62

    Utopia Grate Intake Problems

    hope it works now.... and sorry that I'm so late
  9. ID62

    Utopia Grate Intake Problems

    Hi bkutopia :-) (here could be your name), The ICS switch isn’t directly linked to the ICS motor and yes, the fuse has no proper description but it is just under your helm behind the flap. It’s the 10 amp fuse which is at the top end (I think it’s the only 10 amp fuse at the end, at the...
  10. ID62

    Strange Noise - complete with audio!

    It sounds like a faulty ball bearing which can fail later.
  11. ID62

    loud beep after starting both motors

    I guess it's normal, mine do the same.
  12. ID62

    2007 Speedster Starting Issue

    Hi Banditgrrr, The procedure is described in the maintenance manual on page 204. But it's quite simple, just pressurize the fuel rail and check it for two minutes. One drop per minute is still within the allowed range. Actually mine leaked a lot and it was very obviously that the injector was a...
  13. ID62

    2007 Speedster Starting Issue

    Hi Bandit, Check out the link below. I had equal issues with my Utopia 4-tec and it turned out it was a leaking injector. Your problem sounds equal for me. Once you were driving your intake manifold get flooded from the gas and it will not fire up the flooded cylinder. Since this 4-tec have...
  14. ID62

    diagnosing poor idle- Idle bypass valve?

    The pressure at the fuel system isn't very high. It's somewhere at 45 psi. Easiest way to release the pressure without BUDS is to wrap a towel around the fuel hose at the quick fastener at the pump outlet. When you pull this quick fastener back you can disconnect the hose from the pump and the...
  15. ID62

    diagnosing poor idle- Idle bypass valve?

    You can clean the injectors for yourself. Search in YouTube for "seadoo 4-tec injector cleaning" ;-)
Back
Top