Recent content by Cory880688

The ski does nothing when putting the key on the dess post. If i jump the black/purple wire from the cut off relay to ground lug on battery the relay clicks and the ski powers on and starts and runs fine. I caint pin point where the faulty ground is. Anybody have this problem before?

Update. Went put the ski in the water today and it runs great.

Update. Got the starter back and all the inside was corroded. Its fully rebuilt and back in the ski. That solved my problem and it started up fine on the hose waiting to go put it in the water

The ski sat up for 13 years in a garage..the compression is 150 mag and 148 pto with throttle open. Inside the electric box is like brand new and nothing has ever got wet in there. I guess just from the age all the problems im having is normal just have to fix one at a time and hopefully get it...

Also i read these engines are notorious for the seals going bad and leaking oil into the crank. If this happens when you pull the plugs oil should shoot out of the plug holes right? I dnt get any oil just a gas/oil vapor when cranking

Just dropped the starter off at a local place in town and the guy bench tested it and something is wrong with it. I left it with them to figure out whats the issue

Update..installed the new oem carb rebuild kit and oem fuel selector valve. Ski started on the hose and ran really well. Next day i went to start it again and it would not turn over. Pulled the battery and put on charge. Hooked up my big marine battery and same issue. Pulled the plugs and it...

The kit i found was 72$ and has the needle and seat..does that sound right for the oem kit? First one i bought was about 30

It came in a clear bag so im guessing its not a oem kit. Going to look for a oem kit and replace everything with it. Will look for a oem selector valve.

Would a clogged return line cause the carb to flood out like its doing? Im thinking it running wot its burning all the fuel and when on idle the carb caint get rid of the excess fuel if the return is clogged up..does this make sence?

About the 3 holes yes i got good spray out of all holes in the carb throat

The kit it ordered said it was for the mikuni carb. It did not come with the needle and seat. The needle and seat looked to be in good shape and i didnt put any springs that came with the kit bc i read to just put the factory one back. I cleaned the selector valve and got all 3 passages cleared...

Hello guys im new to the pwc forums. I recently picked up a 95 sp and 96 spi. Im having a really hars time getting the sp to run right. I have already changed the grey fuel lines with black ones, cleaned out the selector valve, rebuilt the carb minus the needle and seat. I tried everything ik...