Recent content by azsxr

The single best mod for the X4. Carving across a glass lake is my happy place

Thanks Brian This is a pump I’ve had for years The seal was leaking and had let some water in so I was replacing the seal and bearings. Thinking about it some more when I removed the bearings the bottom one was kind of stuck. I thought it was the 518 holding the seal but now I think the tool...

I got them from OSD. I’ll have to measure the bearing a little better they were both right about .100

I’m the same way with guns I’ve sold a few over the years and regret it. Good luck

I like the clean “No decal” look myself In my mind faster is always better but that’s just me?

I'm trying to rebuild a pump and I installed the bearings using an arbor press and the shaft won't go in the second bearing. It's kinda tight going into the first one and just gets into the 2nd one and won't go any further? The shaft looks like it has line in it about 3/4 of an inch down from...

It's a 787 I put an O ring on the cover but maybe it was the wrong one?

yes the counter balancer shaft cap on the PTO side of the cases.

I just put the crank case halves together and the cover for the CB bearing rotates in the cases? I don’t remember this happing before but I might not have checked it before? Thanks

Swap N&S see if the leak moves with it?

Don’t know much about VE except that it is rare and good stuff. VE 920 and 970 are the 2 sizes I’ve heard of with single or double plugs per head.

For a stock 96XP

I need the water routing for the R&D pipe? Thanks

This setup is good for a 951 with a pipe

Set of 155 pump nozzles 87/90mm $150 + shipping I also have a 155 85mm exit nozzle