HI,
I am new to this forum, but hoping someone could help. I have had a fair amount of mods done on the ski, but just recently the splines on the jet pump stripped. Pump was rebuilt, new wearing was installed.
I went out on the weekend, and there was vibration on the ski. After an hour or so, ski felt like it picked something up, looked underneath and found the impeller nose cone torn.
Ski booked to go in the shop on Thursday, but was wondering if anyone would know why this is happening? Could it be an alignment issue? Also not sure about the gap between the wearing and the hull?
Some photos of the impeller attached.
Thanks
Peter
I am new to this forum, but hoping someone could help. I have had a fair amount of mods done on the ski, but just recently the splines on the jet pump stripped. Pump was rebuilt, new wearing was installed.
I went out on the weekend, and there was vibration on the ski. After an hour or so, ski felt like it picked something up, looked underneath and found the impeller nose cone torn.
Ski booked to go in the shop on Thursday, but was wondering if anyone would know why this is happening? Could it be an alignment issue? Also not sure about the gap between the wearing and the hull?
Some photos of the impeller attached.
Thanks
Peter
