Un-even output from jets

[TEDUP]

If the engines are running the same rpm's the boat pulls to the right side. Is there a jet alighnment problem or a jet output problem? I've looked at the nozzels and they seem pretty straight. I'm guessing wear ring but they also look good. Is there a way to tell by looking, or do i need to take it to the shop and have them measured for clearance?

 

[howie099]

you can check if the nozzels are spaced probably by using a straight edge on them and adjust as need. The manual should go over that. The RMPs are the same so adjusting the cales you shouldn't need to do.. You could have wear ring or damage on the impeller. I think it will be very hard to remove all the pulling since everything wears differently. Is is a real bad pull or just a slight pull?

 

[TEDUP]

The pull can be overcome by adjusting the rpm up on one side about 400 to 500 rpm depending on how many people are in the boat. I took a flat edge on the nozzels and they line up pretty close. I just would like to go down the lake without holding tight on the wheel to go straight.