Really good cylinder boring shop on the West coast?

[offgrididaho]

Tried searching, same as always, ZERO results!

Are there any great boring shops on the West coast anywhere? Say CA, ID, UT, NV, OR, AZ and WA?

Need to bore my 2,000 951 out. Want someone I can trust not to goof it up.

 

[shamrock246]

I hear good things about Groupk.com.

 

[etemplet]

If you can.... find someone local. It's not that complicated. Just a hole. You can get it done same day or a couple of days and no shipping.

 

[racerxxx]

I'm on the east coast and I send all my stuff to GroupK. Harry and his crew are legit. It's not much more for me to send them out to him vs having someone near me do them and screw them up. That has happened, hence my switch to GroupK. Group K – PURELY TECHNICAL Online

 

[mikidymac]

Group K.

Unless the local shop does a lot of 2-strokes and is good at chamfering ports avoid them.

 

[etemplet]

Group K.

Unless the local shop does a lot of 2-strokes and is good at chamfering ports avoid them.

We'll never agree on this. Small coarse 3 corner file and 10 minutes removing the sharp edges with a little taper. Done. Anybody can do it. (No die grinder or any type of rotary grinder)

 

[racerxxx]

We'll never agree on this. Small coarse 3 corner file and 10 minutes removing the sharp edges with a little taper. Done. Anybody can do it. (No die grinder or any type of rotary grinder)

True but when you go to a restaurant do you go in the back and finish cooking your dinner? No, you don't. A reputable shop should finish the job and chamfer the ports, that's what you pay for.