Ok this has been my project ski since about May. I bought it and it had a bad top end. I pulled the motor and bored it one stage over with new WSM top end kit. Rode it for a while then in mid July the oil pump failed and i lost the top end again. I bought new sleeves and went back to standard bore with another WSM top end kit. I just about an hour ago finished putting the rebuilt motor back in. It has ZERO hours on it and will be broken in tomorrow. I also replaced all the crankcase seals but i reused the crank as it was fine.I switched it to premix with a WSM block off plate. It was custom painted in May. It has a custom seat cover to match the paint. I have spent almost $1000 on Top end kits and machine work to the cylinders and have a little over $4000 in it total. It comes with a single trailer. This ski has been rebuilt top to bottom. It does have a few problems. It will need a hood shock and there are one of to scratched in the new paint job. (my friend hit it with his wave runner while we sitting at the dock.)
Location is about 30 miles south of Wichita Falls Texas
Asking Price is $3000 Or Best Offer (i might go lower but no much lower)
Working on getting more pics. Like engine bay and so on. These pics are in the middle of June right after it was painted.
Location is about 30 miles south of Wichita Falls Texas
Asking Price is $3000 Or Best Offer (i might go lower but no much lower)
Working on getting more pics. Like engine bay and so on. These pics are in the middle of June right after it was painted.
Last edited by a moderator:
