carb rebuild kit help

[tractng]

I just bought this kit for my seadoo 1996 SP

http://www.watercraftsuperstore.net/PWC-Carburetor-Carb-Kits/709SB004.html

Would this kit have the spring size for my jet ski? I read on another forum which I am confused, the member stating that this kit might not have the correct size.


What else do I need? Needle and seat assembly? At his point, I don't know what size I need (just look over the service manual too ). I am assuming its a stock jet ski.

Thanks,
tony

 

[shakedown]

You will need a 2.0 needle/seat. your spring part # would be 270500130, that would be a black spring I think, someone correct me if I'm wrong

 

[tractng]

You will need a 2.0 needle/seat. your spring part # would be 270500130, that would be a black spring I think, someone correct me if I'm wrong

Is the spring stated (270500130), part of the kit?

tony

 

[daverade]

aright homie...dont tripp.... use the full rebuild kit accept the spring, use your old one...check pop-off when done if n/s hhhiiiiissss, then replace n/s....if they "PPOPP", then their good you just need to adjust to correct accurate P.S.I.