• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

2011 GTI 130 dies frequently and randomly. Bypassed TO switch. same issue. Dies cold and warm. Electrical. Starts right back though.

Status
Not open for further replies.

cbudinger

New Member
Bypassed TO switch. same issue. Dies cold and warm. Electrical. Starts right back though. codes P1505 P1661 C2111 Suspect the ecu. Requesting troubleshoot advice. A new Rotax ecu is expensive and not wanting to replace it with same issue. Any help is appreciated.
 
Last edited:
I would check the power cable going from starter solenoid it has 2 red thin cables going to the fuse box, one of them can be bad inside non visible damage
follow those 2 cable one is going to the charging fuse the other one i believe goes to the relay Which instead send power to your display.
 
I would check the power cable going from starter solenoid it has 2 red thin cables going to the fuse box, one of them can be bad inside non visible damage
follow those 2 cable one is going to the charging fuse the other one i believe goes to the relay Which instead send power to your display.
thanks for the advice. it's fixed - not the exact issue you said but you pointed me in the proper direction. Corroded relay connection
 
Status
Not open for further replies.
Back
Top