2008 gti wear ring plastite set scews

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.

ZR7000guru

New Member
Hi guys I'm installing a new wear ring in my ski and was wondering what size drill bit to use for the pilot hole for the screws. Also I lknow you can't drill right though so what kind off depth for the holes . I'm useing the oem plastite screws washers and wear ring
 
Just match a drill bit a few sizes smaller than the screw. You can go one size smaller than the solid part of the screw not counting the actual threads. For depth just put a piece of tape on the bit the same length as the screw.
 
At one time I was able to look at a BRP manual and it said what actual size drill bit to use .I can't find that information any where now. I"ve had so much trouble keeping a wear ring in this ski I want to do everything by the book. Part of my problem before is I didn't drill out pilot screws.
 
Status
Not open for further replies.
Back
Top