• This site contains eBay affiliate links for which Sea-Doo Forum may be compensated.

1997 gtx top end question

Status
Not open for further replies.

trabich

New Member
All of you guys on this site have been such a huge help. Thank you again.

Now, I am putting the top end back together on my 97 gtx. Had to replace pistons and have cylinders bored. I have all new gaskets and everything ready to go back together. Are there any tips you can give me about the re assembly? Looks like I need to be real careful on putting the new needle bearings and pin back in the pistons. Would it be wise to use liquid gasket in some areas? I also need to check the settings on the carbs. can anyone help me there. what are the factory settings and where the heck are the needles?

Again, thanks so much for the help. I had ended up spending every dime I could on this project and wasn't able to buy the manual. Your help has been greatly appreciated.
 
Status
Not open for further replies.
Back
Top