Recent content by lineofsight

Thank you. Apologies for delay in response (some reason could not see replies). Awaiting the plugs and will try (was surprised how soft the plug seemed - proper tight bit and turned in it like butter - had used the proper pipe dope and torque too). Thank you, appreciate the tips and...

Likely guessed it, one rounded... Challenger 210. Anyone able to tell me if aluminum or stainless steel (211500001) - trying to decide whether want to attempt drilling / extractor and am a little more hesitant with stainless steel. Seemed soft in the manner it rounded thus thinking...

Welcome to send an offer. Now see black lines in a couple photos across the carpet, these are not dirt but fold lines (sitting higher in photo / different light).

Went with Carlisle HD radials when replaced my tires - came in the same odd 185/80/13 size and the "HD" version had comparable load rating for the radial (otherwise seem to run lower). They look larger radius / less clearance in fenders, would have a real good look if want to increase overall...

Same, sent the drawings over with part numbers, all sorts of help - was amazed.

This carpet was in use 2012-2017 during which time to boat saw ~50 hours on motors. Fair-good condition, all snaps in place, no stains. Havent tried scrubbing bottom to see if cleans up (dont see it), photo to show no damage / rot. Located in Vancouver BC, can ship from Blaine. Price...

Paid $509.99 three years ago for Challenger 210 SE and shipping was included (perhaps as forum member?). Service was good, the cover is excellent. Two ratchets are mounted on the back, each is encased in a zippered rubberized pouch (compared to single ratchet on side on OEM with pouch same...

Know others here have had them play hide and seek as well, found a source. https://www.corsa-technic.com/item.php?item_id=721&category_id=117

I changed mine primarily because boat was 2 years old off the lot and after had it for 3 years figured about time in terms of inhibitors, wetters, whatever may be in the solution (mine is stored in garage that stays above freezing, one of the benefits of being south on the wet coast).

Thanks, looks like a good piece of kit.

GB387, no kidding on not trusting a friend with the rope, learned that this summer. At least turned off motors in time that could use tool made from broom handle (barb like cutout on one end hook screwed into other end) to remove without cutting rope or removing grate. Was worried that if cut...

Same experience. Replaced the ski locker latch twice, stern locking latch and bow latch have fared better.

Good to know about the booster ball. I've been running a 3 person tube off the ski pylon for years, so far so good.

Did it a two years ago. Ended up phoning prestone as labeling unclear on additives and believe there are two you don't want for the 4-tec (silicate and borate?), a person answered and the bottle I had in hand (in the store was good). Cannot recall the specifics but followed the manual and...

So about to pull plugs to crank storage oil out of cylinder, coil comes out without plastic cover and part of sealing cup... Managed to remove plastic sleeve - in pieces... Hence, does plastic sleeve serve a purpose, or okay to run this week without...