69DartGT
Member
Hello, I thought I would post how I fixed the speedometer sensor for our 96 GTX's. This is for the 2 wire sensor with temperature sensor.
These are the components I replaced and their part numbers.
This is the sensor.
First thing I did was to cut the wire flush with the case.
Then I drilled a series of holes into the potting. There is no use in trying to save any of the old components because I replaced all of them.
Now I used a sharp little chisel to scrape out all of the potting.
After all the potting is removed, reinsert the wire with the ends stripped.
Now I soldered the diode to the right leg of the SS41. The side that has the printing and the 2 angles on the SS41 has to face the paddle wheel or it will not work.
These are the components I replaced and their part numbers.
This is the sensor.
First thing I did was to cut the wire flush with the case.
Then I drilled a series of holes into the potting. There is no use in trying to save any of the old components because I replaced all of them.
Now I used a sharp little chisel to scrape out all of the potting.
After all the potting is removed, reinsert the wire with the ends stripped.
Now I soldered the diode to the right leg of the SS41. The side that has the printing and the 2 angles on the SS41 has to face the paddle wheel or it will not work.
Last edited: