XP and GTI logo dimensions

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.

az5oh

New Member
Good morning! I'm in the process of restoring my 1995 XP and 1996 GTI and have gotten to the point where I'm ready to purchase all new graphics. My color scheme is attached, I've recreated the lowercase Bombardier logo in the correct dimensions, downloaded a high-res SEA-DOO logo off the web, but I cannot find the following anywhere:

- dimensions for SEA-DOO logo on both the 1995 XP (assuming this is likely the same for all X-4 hulls) and 1996 GTI (assuming this is the same for all 1995 GTX, 1996 GTI, GTS, etc hulls). CAN ANYONE PROVIDE THESE?

- high-quality logos for both the "XP" and "GTI" logos in the same format as the photo attached. DOES ANYONE HAVE THESE FILES?

Thanks in advance!

Picture 9.jpg
 
I believe the ones on the x4 bulls are 3” high by 25” long. Not sure if ur using a vinyl printer or cutter. I used a cutter and just searched “SeaDoo logo vector”. Came right up. Just had to remove the dolphin within my program
 
Status
Not open for further replies.
Back
Top