cncsignman
Member
Hey all. Did a top end rebuild on a 717 back in July. Motor started and I checked compression. Had 150 in both cylinders. I started it again and then heard a screeching noise and immediately cut it off. Motor was very hard to turn by hand. I took the plugs out and tried to start again but made a weird noise. The starter is turning the flywheel but I can’t figure why it would make this noise. I’ve attached a video so you can hear it. Help!!!
https://www.dropbox.com/s/1deu6gn8kn82gph/Video Jun 28, 5 34 37 PM.mov?dl=0
https://www.dropbox.com/s/1deu6gn8kn82gph/Video Jun 28, 5 34 37 PM.mov?dl=0