Water sports
Active Member
With pressurising the carburettors, petrol tank and oil system what is the easiest way of explaining how to do this I am a little bit lost here, I have brought a pop off gauge that goes up to 100 psi, could you explain in detail with ideally photos if possible how to do each pressurising and if I need to do more than those three as I guess I'm going to have problems starting the engines. I have replaced all fuel, water Holes and next some of the oil lines. (with the oil line, I noticed where this attaches to the engine the end of the piping is hard do they have a reinforcing piece inside the hose where this attaches to the motor)