Seadoo 3D 2 stroke--warning light keeps flashing after a few minutes

[jasonberger1@hotmail.com]

I bought a 2004 or 05 Seadoo 3D non fuel injected. Don't know exact year exactly. We don't have a Seadoo dealer around here so I thought I'd throw this problem out there. My jetski starts and runs fine for a while, then the warning light starts flashing red and I lose some power. If I shut it off for a while or a few minutes it seems to run ok briefly until the light comes back on. It appears that water is circulating through the ski and is not overheating. Anyone have any suggestions. Thank you

Jason

 

[Dr Honda]

Well... what's the warning light? If it's the over temp... it could be overheating... or the sender could be bad.

FYI... the last 2 digits in the hull number is the year.

 

[jasonberger1@hotmail.com]

not overheating

The jetski appears not to be overheating when the light is on. Is there a safety mode they go into when some warning light or temp light is on? If so can the sensor be bad and where is it located?

 

[Dr Honda]

Yes... the newer 3D's will go into limp mode when there is an issue.