2014 gti 130 se seadoo flush port question

Note: This site contains eBay affiliate links for which SeaDooForum.com may be compensated
Status
Not open for further replies.

ClassySeadoo

New Member
How long should it take for the water to start flowing through. No quick connect. Straight hose. I followed the intructions from the owners manual. But shut off after about 15 to 20 seconds with out seeing any flow of water. Is it blocked or should i have waited longer. When detaching hose it did seem to have pressure build up.
 
Should be pretty quick to start (seconds)...
I had a similar issue recently with one of my 2011 GTI's. It ended up being some weeds/dried brush in the intake of the quick connect. I was able to finally remove it with a coat hanger wire...nearly 12-18 inches in... It seemed easier when it was all dried up.... Hope that helps.
 
Yeah it should be within a few seconds of turning on the water. And it isn't dripping out, it would be noticeable, a nice steady stream. Check for blocks through the port in first. If you weren't having a performance problem it would make sense for it to blocked there.
 
Status
Not open for further replies.
Back
Top