stator

So this past week I decided to take the wear ring off and smooth out some low spots with jb weld to see if I could get back some lost performance due to cavitation. Got it all done and it looked great. Sunday I decided to haul it out and see how she ran and just like I thought, ran like a dream...

Situation: Local dealer pulled 04 GTX LTD motor. When motor blew supercharger, it did some collateral damage to both oil pumps, starter gear, etc. I'm starting to reassemble. I noticed my flywheel drum that rotates around the stator has a stamped, fingered THINGY that sleeves around the drum...

I was wondering if anyone on the forum knows if the is normal that the flywheel cover get hot The ski runs great and the engine feels cold to the touch but the flywheel cover or magneto cover is hot Thanks for your help

hello friends I have a rookie question I have a 1997 gti and the flywheel cover them extremely hot engine block is cold exhaust pipe too is this normal or have any problem thanks for your help

Hi, i have a 1995 Sea Doo with 55 HP 587 Rotax Engine. I had Problems with the Regulator, the Battery was empty after a 30 Minute Ride.

The problem with the DI not charging has always been the Rectifier/Regulator for me, and most everyone. I have two 2001 GTX DI, and I have subbed the Rec/Regs around to verify they both work in the "good" DI. I measure 13.5v at idle, increasing with rpm. I even tried a new Rec/Reg I have. I...

I am looking for a stator for a 97 Seadoo GTS with a 717 engine... That stator I have is bad and keeps blowing my 15amp fuse and I have had the stator tested and it is bad so I need a replacement... Please PM me is you have one or know where I can get one... You may also E-mail me at...

I am fairly new to PWCs. I bought a used SeaDoo 2000 Model 5515 so I could learn prior to buying something newer. I believe this is a GTX Bombadier. Under which area would I post the following questions? I have a problem it chargering the battery. It will run for a while and then have a...

whats up guys! Im new to this forum and jet skis! The other day I bought a 95 sea doo xp not running with a trailer for $300! the guy I bought it from said he ran it fine for years and it started blowing the 5 amp fuse inside the MPEM box. He told me he was told it was the stator. He went as far...

Wondering Everyones opinion on these three parts. Finally got the impeller and stator and wear ring off. I really want to do the jb weld trick on the wear ring but my fear is its to far gone. Anyone seen one this bad and JB weld work. Also as far as the impeller and stator go. Is it...

here is the story. i was out jetsking on my 95 seadoo XP, got it up to full speed, when about 2 minutes in, it just stopped like someone pulled the key. no electronics, no starter motor, no gauges, nothing. got it home. 5 amp fuze was blown( neither of the 2 15s are blowing). then i...

I got a 96 GTI and i am not getting any power or beeps, the 5amp fuse is blowing as soon as I put the battery in the boat.. After some t/s i removed the electrical connection coming from the stator/mag housing and it will not blow the fuse.. MY stater fell out of the housing last time i was...

Anyone had a leaking stator? You can fix it yourself ! Recently got a m2 jet drive with 250 optimax attached to a 22 foot Polaris Made by BAJA one ton (2050lbs) boat. While catching up service, I found that the drive oil was like tar (pretty nasty) but no water in it. I changed it out with...

Simple question.... Is it possible for a bad stator to cause a loss in spark to one cylinder? I have an intermittent low idle issue (mostly coming down from high RPMs) and determined today that the cause is the ignition is not sparking on the MAG cylinder's compression stroke, but ok on...