rfi

  1. K

    2005 3D RFI no spark on 1 cylinder testing with CanDoo Pro ECM???

    trying to track down a fault on my 3D RFI. only runs on 1 cylinder constantly. Connected candoo pro and when individually activating coils with plugs removed and earthed can only get 1 to spark. Tested resistance in wiring between coil and ECM and both test perfect (0 ohms), but only 1 will fire...
  2. G

    1999 Seadoo GTX RFI

    Im currently wanting to purchase a jetski but i have never had one. I have a boat and know a lot about boats but i dont know a whole lot about jetski's. A guy has a 1999 gtx rfi and he has about 60 ski's total. He bought out a dealership and works on them regularly. He said with the gtx he is...
  3. G

    2002 gtx rfi issue with starting on water and bogging down

    Hi all, just after a bit of help with my seadoo gtx rfi 2002, basically when i have it out of the water on the trailer and run with the hose connected the ski starts and idles fine everytime , revs out to about 6900 rpm and sounds healthy, once i put it in the water sometimes it starts and...
  4. R

    2004 gti le rfi

    I have a 2004 gti le rfi that will fire right up when cold. After 5 or 10 minutes of riding it will start to bog and have poor acceleration. If I shut the machine off I will have to crank it for a very long time before it will start. Is there a way to pull codes without a buds set up? I just...
  5. B

    2005 Sea Doo GTI LE RFI PROBLEM!!!! NEED HELP!!

    i just bought my first jet ski its the 787 engine the better one the problem i have with it is it starts normal land and water. On land when running the RPM are perfect also when i rev it the rpm are perfect on land. Once it is in the water the rpm are too low even at idle. When i pull the...
  6. billybullets54

    04 gti le rfi hard to start after it runs for 30 minutes

    oK HERE WE GO when you first put in water its hard to get it to idle until it warms up (1300-1600 rpm) then will idle fine. After a 20, 30 min ride you shut it off let it sit for five to ten minutes and wont start easily, you have to pull WOT to get it to start then its fine again till you shut...
  7. B

    Need Help with 2000 GTX RFI won't rev over 3000rpm, starts fine

    Hello and thanks in advance for any advice. I bought a 2000GTX RFI with the motor in boxes (appeared to be a seized crank but was a piece of ring caught in cylinder) so i purchased a BRP short block, installed and was on the water. The machine ran great with the exception of 12V low alarm...
  8. T

    2001 GTx RFI speedometer wont work

    Just bought a 2001 Sea Doo GTX RFI. Has an analog speedometer as well as the digital speedo/RPM/hour meter /other stuff combo.. everything works but the speedometers. I checked the flywheel and it looks to be in good shape. I don't have any of the manuals on this so I am shooting in the dark...
  9. J

    98 GTX RFI losing running on one cylinder

    Hi Everyone, I took my 98 GTX RFI out today and it was running great for about an hour and a half. At this point I lost the rear cylinder. I checked the plug and it was damp with oil but i couldn't tell if there was fuel. I checked for spark and that was good, I even changed the plug but...
Back
Top