Hey guys. I am in need or some more help. I stripped down the motor and whatnot for rebuilding purposes but before I put the RV cover and carbs back on, I would like to test my oil injection to make sure it's working properly. Is there a standard way I should do this? Have any of you all...
So I am rebuilding a 717 and got some new crank seals, I have been fighting with the rear PTO since the start. I have an old drive shaft that I am sticking inside the spindles and cranking on to try and bust it loose, I heated the shit out of it, and now, I tweaked the Woodruff key on the...
I am new to the forum and recently purchased an 01 GTX Di. The haul is great only 43 hours, but the motor is completely melted down and it was missing a lot of parts. The oil pump drive shaft failed. The previous owner started parting it out and then sold it to my friend who then sold it to me...
My 1997 Seadoo GTS has been in the family its whole life and this forum has been very, very good to me. So thanks for that. But now I am having a issue now that I cant seem to find any conversations that fit my issue completely.
Here goes.....
Oil Light came on...
Here it goes, I rode my 95 xp for about 2 hours. I got back and checked the oil level and it didn't move. Seems like the oil injector is not working properly. From what I have looked up, the oil injectors seem to go on the 95 xp's often. What is the next step?
Should I just pre-mix into the gas...
Hi,
We had a little accident and tipped our Seadoo RXP 2007 over, it was upside down for to long and the engine compartment was flooded with saltwater. We flushed the engine and the engine runs fine on two cylinders. But on one of the cylinders the injector is constantly spraying maximum of...