Search results

  1. Digdog

    RXT260 Not running please help

    The Riva ecu would need to be calibrated to your throttle body , or any new ecu would need the same.
  2. Digdog

    Supercharger failure

    Very good, there are a couple of screens where the oil pumps are that need to be checked also. Also a screen in the intake, but I am sure you checked that already.
  3. Digdog

    Supercharger failure

    You need to look in the intercooler , intake manifold, throttle body and more than likely take the head off and inspect the cylinders and pistons for damage. With that much of the turbine missing I doubt that it is the only thing damaged, if the washers and the bearings are gone in the...
  4. Digdog

    RXT-X won't go over 55 mph - Supercharger ??

    You need to know what RPM it is running at when its going 55mph, you need to fix the tach first or it could be an expensive few guesses before you figure it out.
  5. Digdog

    Partout 3 rxp and 2 rxt

    What year are the RXT's , where are you located?
  6. Digdog

    Low compression on all 3 cylinders

    Sounds like the intercooler was leaking and the rings seized up allowing compression by, did anyone check the intercooler?
  7. Digdog

    2010 130 GTI TOPS sensor location

    I believe on yours its under the crankcase breather vent on the end of the head.
  8. Digdog

    2011 Rxt 260 top speed and rpms

    Have you owned it since new? Low rpm can be caused by low power output, software limiting the rpm , too much impeller (if someone changed it), possibly the pump bearings going bad. Tell us a bit more of the history behind it. Does it go above 7200 rpm on the way to 62mph? I think US versions of...
  9. Digdog

    2013 RXP X 260 with fault codes

    Here are some things to check from my manual, if you pull the plugs off of the computer the pins are listed although you may need a magnifier to see them.
  10. Digdog

    2013 RXP X 260 with fault codes

    You have a problem with your manifold pressure sensor and the TOPS sensor which would point at a wiring problem which causes the computer to run in idle. Look for wiring faults, bad ground would do it also. Maybe check your intercooler for a water leak, keep your fingers out of that throttle...
  11. Digdog

    Solas impeller and salt water

    I bought a Solas with the aluminum cone and it leaked right away, I can run the rubber OEM cone for months with no leak. I changed it because I didn't want the splines to corrode away.
  12. Digdog

    2008 - Lagging 3 to 4 times on turnover before engaging throttle to start

    I would say your starter is dragging causing a high amperage draw, take it out and have it tested. There are also a lot of issues with the solenoid failing from high current draws, but that would not cause heated cables. A bad cable could also cause the symptom, maybe remove it and have someone...
  13. Digdog

    2002 Seadoo gtx 4 tea taking on lots of water!

    Carbon rings when worn are a major source for water in the hull.
  14. Digdog

    2004 gtx not getting fuel

    When you press the start button you should hear it pump up to pressure and your dash should come to life. No pump noise means no power or a dead pump if there is power at the connector, relay inside the computer could be toast, bad wiring connection possibly or the ground is not good. I would...
  15. Digdog

    2007 GTI 130 solenoid HOT

    Why did the shop replace the solenoid ? Did they give a reason?
  16. Digdog

    2004 gtx not getting fuel

    Yes do the pressure test first, if you have proper pressure and it holds then you probably have a bad sensor. What made you think it was not getting fuel to the injectors?
  17. Digdog

    2004 gtx constantly killing rectifiers

    Charge the battery with a normal charger at 2 amps for at least 6 hours and let it rest for an hour or two then test the voltage of the battery.
  18. Digdog

    2017 GTX230 Ltd. - Help!!!

    I would check the relay inside the fuse box, you can see if it is working by using a 9 volt battery and touching it to the 85 and 86 posts, to test for continuity check the 87 and 30 posts. If it is bad you can buy them at automotive stores or the dealer.
  19. Digdog

    4tec stator replacement procedure

    Wire from the switch points down, but I think you have another problem. Look at the diagnostic here, maybe it will help you
  20. Digdog

    2005 rxp starter cranks engine for about 2 seconds then free spins. What's the cause?

    There are several 'names' for the same part, Bendix is a trade name that alot of people still use and you are correct as it is listed as the Bendix drive in the parts manual by BRP. I have always called it a starter drive))
Top