Shop Discount Sea-Doo Parts

Search results

  1. E

    96 sea doo challenger speed sensor.

    I have a 97 with single 787, would you like pictures?
  2. E

    1997 Challenger 787- No Propulsion- HELP

    Replaced that and the Neoprene Pump ring seal.
  3. E

    1997 Challenger 787- No Propulsion- HELP

    Got this boat last year from a friends neighbor (original owner). Went thru engine for rave valves. Took out first time since engine work this weekend - wont go forward. Engine ran fine, and would idle forward, but as i accelerate it was like putting a car in neutral, hit 4500 rpm and would not...
  4. E

    97 challenger Idle question

    makes sense- thanks alot.. Crossing my fingers that all goes well when in lake- I always get nervous after engine work.. Thanks
  5. E

    97 challenger Idle question

    Runs real nice, if available I can call you with it running to hear it. Thanks
  6. E

    97 challenger Idle question

    Well finished late winter with engine only quickly started. Finally got sunshine so trying with water hose to be sure all ok, seems high. Tach reads 3k if they are accurate. Want to be sure all good before take out on lake Thanks
  7. E

    97 challenger Idle question

    Idle screw one turn on stop, Cable on throttle is al the way loose, Fresh rebuild first time run with water she idles high 3k, just sounds high. How can I lower it Thanks
  8. E

    1996 seadoo challenger service and owners manuals

    I HAVE A PARTS LIST- HOPE THIS HELPS...
  9. E

    1997 Challenger Single 787 - Fuel to New Rebuilt Engine

    I am not seeing any temps above 50 here in Michigan coming up- so I think its getting put to sleep for winter.. Thanks everyone...
  10. E

    1997 Challenger Single 787 - Fuel to New Rebuilt Engine

    Wound up removing filter, putting in primer bulb, pumping till fuel went to carbs, took off primer - filter back on. Cranked couple times and she fired.. Holy crap it ran- LOL Only ran two times for about 3-5 seconds each, fresh engine rebuild. Thinking about just putting it away like that till...
  11. E

    1997 Challenger Single 787 - Fuel to New Rebuilt Engine

    Is there a way to get the fuel to engine quicker? I had removed engine, rebuilt, changed fuel filter. There is a lot of hose between filter and carb.. Now all back in and cranks fine, I am afraid to keep cranking- that it will load up with injection oil. Oil lines were primed.. Is it OK to keep...
  12. E

    1997 Challenger single 787 - Garden Hose Connection Location?

    Yes it does have a cover with tether. I have seen videos of hose connections at transoms on jet skis, so was not sure. Thanks Any idea why the other at the transom..
  13. E

    1997 Challenger single 787 - Garden Hose Connection Location?

    Looking at my parts manual it appears that one of the fittings at transom is from the Bilge. However the other and the one at gas filler are appear to be the same style. Is one for flushing, after ocean riding and the other for garden hose to run out of the water? Thanks
  14. E

    1997 Challenger single 787 - Garden Hose Connection Location?

    I have 3 fittings on my boat, 2 in rear at transom, not in pump area, and 1 under the hood near gas tank filler. I just finished putting the engine back together and want to run for a bit, but need to have water running thru it. There is a garden hose connection up near gas tank filler that...
  15. E

    1997 Challenger - Foam Blocks in engine compartment?

    Each is a thick piece of foam with some fiberglass 1/4" thick panels on each side. Any idea... Thanks
  16. E

    1997 Challenger - Foam Blocks in engine compartment?

    These were loose in engine compartment, one each side, not shown in parts list. Where do they go and what are they for. Thanks
Top