Shop Discount Sea-Doo Parts

Search results

  1. T

    Crank bearing

    All the other bearings are fine just the 2 on the flywheel side
  2. T

    Crank bearing

    Anyway of getting this bearing sleeve off, the bearings came out in pieces when I separated the case ?
  3. T

    Blew flywheel cover gasket

    Just gotta get the inner bearing sleeve off and I can pop the new ones on and the crank will be back into working order
  4. T

    Blew flywheel cover gasket

    Crank bearings Where shot on the flywheel side
  5. T

    Blew flywheel cover gasket

    well did a compression test and got 120 on mag side and 110 on the other , no wonder it was a b**tch to start haha
  6. T

    Blew flywheel cover gasket

    Looks like someone put the 657x cover on a 657 motor causing detonation .I never noticed, thought it was the 657x cause of the b38i carbs fml. But I found a guy selling a good 657x for 600$
  7. T

    Blew flywheel cover gasket

    ya im gonna tear it down and do a full rebuild. obviously the cylinder pressure/fuel must of leaked down to the crank to cause this to happen , explains the hard starts and bogging i was having . I bet compression is shot in one of the cylinders causing all the headaches ive been having
  8. T

    Blew flywheel cover gasket

    Well just my luck I got my new solinoid in and when out on the 94 xp and it backfired through the flywheel cover and blew part of the gasket out now it wont start ? It over heated when it happened and I noticed the large line on the exhaust was blown off fml !!
  9. T

    94 seadoo xp 657x

    thanks but how would i measure this ?
  10. T

    94 seadoo xp 657x

    kk where can i find the chart with a printout of the impeller ?
  11. T

    another newbie question

    no but i run the seadoo for 30 seconds on the trailer after everytime i pull it out of the lake , helps get any extra water out .
  12. T

    94 seadoo xp 657x

    awesome thank for the info i will definitely change the impeller and raise the pop off a bit more if i continue to have problems
  13. T

    Manifold gasket

    that 518 is for the bottom of the cylinder jugs gasket
  14. T

    94 seadoo xp 657x

    hey guys waiting on my starter solenoid in the mail so i decided to recheck my carbs in the meantime since it was having part throttle bogging. My question is, is it ok to have my pop off at the high end of the specs the xp manual says 16-21 psi and both my carbs i have set to pop off at 21 psi ?
  15. T

    1997 Seadoo GTX fuel problem

    make sure your pulse line isn't loose or cracked as well
  16. T

    1997 Seadoo GTX fuel problem

    petcock is a fancy word for the fuel selector , i had to bypass everything and run the res line from the tank straight to the carb and then she ran fine . doing this determined that the problem was either the fuel selector , clogged or cracked fuel line or filter/housing. turned out that the...
  17. T

    RESTO 97 trouble

    marine batteries are a b**ch they dont last long and some are just defective
  18. T

    RESTO 97 trouble

    when mine did that it was a bad starter the wires inside where toast ... try jumping the solenoid first to see if it turns over if not its either a bad battery/connections or starter
  19. T

    Won’t start...

    yes def check to make sure its not a wiring issue before forking out the $$$ for a new one ! shopsbt.com for parts
  20. T

    Won’t start...

    its inside the front storage take out the storage box and look on the side beside the fuel tank its a grey plastic box the mpem is in there .
Top