Recent content by xp951

  1. X

    96xp & 98XPL on the block

    I am selling them both with 2 place aluminum trailer, also have 2 place hoist. Call or text for details 810-599-2514 Brent. Located in Linden MI
  2. X

    98 XPL cooling system pluming?

    Well, the 2 plastic tubes are missing. How are the fastened in there epoxy? I tried to pull them out of my X4 but didn't want to mess them up?
  3. X

    98 XPL cooling system pluming?

    My question is what is wrong when it's blasting water into the hull?
  4. X

    98 XPL cooling system pluming?

    I found another couple leaks. These elbows that go to the bilge tubes are spraying a constant stream when cruising out of the hole in the elbow. Any idea why this is happening? I can't find anything in the manual.
  5. X

    98 XPL cooling system pluming?

    Looks like the bellows has a small hole poked it it from a rusted out clip. Thanks for the reply's guys.
  6. X

    98 XPL cooling system pluming?

    Looking for some help/clarification on my cooling system pluming, as mine is different than the manual specifies. I have attached a couple pics. First is the "t" fitting coming off the motor water return hose that goes to the water regulator. The second is the manual with my routing in red. I am...
  7. X

    96 XP ....no power....nothing

    Well, i thought I would give this thread another bump, the ski has been sitting on a stand in my garage for a couple months now. I appreciate the tips, but does anyone have any more? Once again, I have no peeps or anything when I plug in the DESS, or when I hit the start button.
  8. X

    96 XP ....no power....nothing

    i finally got a chance to mess around with it this morning. I checked voltage at the starter relay in the ebox and i have 12 volts when I check continuity at the relay. All the wires in the ebox look good and tight with no corrosion.
  9. X

    96 XP ....no power....nothing

    Thanks for the tips, I did check the grounds with my test light and all is good there. I pulled the plugged on the front of the engine and it was corrosion free with a good amount of dielectric grease on the contacts. i have checked all the fuses that I could find front and rear box and...
  10. X

    96 XP ....no power....nothing

    Looking for some help to get power back to this thing. End of last season I went to start it and plugged the DESS in and no beep...no nothing when I hit the start button either. I thought the battery may have drained down since sitting on the hoist not being used, but I switched with my 951...
  11. X

    98 xp taking on water

    Ok, i backed it in on the trailor for about 15 mins and not a drop, i started it and ran it for a few on the trailor and nothing. I took it out for a 15 minute rip and pulled it out and the water was half way up the bilge pump. The water was warm when I pulled the plugs to drain it. I am...
  12. X

    98 xp taking on water

    Where is the carbon seal located?
  13. X

    98 xp taking on water

    My xp takes on water at a petty good rate... Maybe a couple gallons in 20 minutes or so. I ran it on the hose for about 10 mins and didnt find anything coming from the exhaust. I am going to splash it today without starting it and see if I can see anything coming in. Any ideas or past issues...
  14. X

    96 XP wont break a plane/2.5k RPM and just shakes violently

    Sounds like rectifier to me as well. I just went through the "exact" same issue. Replaced rectifier and it is running awesome. Another big THANKS to the guys on this site!
  15. X

    96 XP goes into intermittent 'limp mode"

    Ok, when i originally disconnected the rectifier, I had a 2-fold problem, i was that is was boggy like limp mode, the second was that it would just shut off suddenly. When i disconnected the rectifier, it would still shut off. Now I disconnected the rectifier, and it ran great, for a good 10...
Back
Top