So I took off the VENT VALVE to get the Super charger off and when I went to put it back on the washer that goes between it and the timing chain gear Fail down into the block and I can’t find it I have tried using a magnetic screwdriver and a piece of Metal wire no luck any help would be great...
Ok I will put some wd 40 down it and check again the first time I did a compression check it was 75 then 25 and then 50 so it’s not giving me a Accurate reading
So I hooked the jumper cables to the starter wire and put the key on and put a little gas down each jug and it fired right up but I still can’t crank it with the starter button and cylinder 1 has 149 psi cylinder 2 150psi and cylinder 3 has 50