Recent content by Seadoo Brian

Anyone work or recommend a shop that works on seadoo 2 stroke boats? 92 Sportster

Temp alarm goes off when motor is cold and when motor is not running on vacation cant get new temp sensor how do I disable to use the boat

Thank you

Can anyone tell me the screw settings on these two carbs for a 96 Seadoo Sportster boat.how many turns out for each screw. The top one are all the way in and bottom ones are 1 and a half turns out. Got the carbs like this when I got the boat. Just rebuilt carbs, no idea on settings

Wilk do, thx

I have not gone over fuel system since it revs so strong when testing in driveway.

New to me boat, bad cavitation, replaced wear ring impeller, replaced carbon ring and bellows assembly, boat started and reved great in driveway, checked for leaks . At lake pulled front end and felt strong for 45 seconds and started bogging, looked in engine compartment and found pin hole...

thx, looks like I have an after market bileage pump

Sportster revs when testing in drive while running with water hose. Out on the water bogs down under power, any advise?

Where does the water sensor plug into I have a plug but cannot find where it plugs into 96 Seadoo Sportster

Exhaust port 6mm hose melted at one end

I will check with them and look at the exhaust port in the hull

Hose is split, cant seem to find it on any sites that sell parts, anyone have any ideas? The hose runs from the round water box to rear hull.

Less than a dime, I couldn't get a 4 thousandths feeler gauge in between the impeller and new wear ring. The pic with the carbon ring on the shaft shoulder has a lot of play, how tight should it be?

What's the best place to order a rebuild kit for the bellows and carbon ring, etc.