Recent content by RON@COMMONWEALTHUSA.NET

i;ve done about all you can do to these engines without going inside engine, i.e. value springs, cam, etc. I owned a 40; ft. Fountain boat with Bob Teague big block engines(2) loaded and always an issue with engines, etc. so i wanted my set up for OEM stock reliability. I'm in the 79's at sea...

you need the fizzle intercooler and fuel regulator. your eco maybe too old for the right flash? Have many options on the same engine in 150 speedster including x charger, going to XX or larger wheel. best to you

sent you some pictures of the mods i did on 2009 150 Speedster that started with the 215 engine. I've done about all you can do with this engine without going inside for valve springs, etc. Mods include: X charger w/Riva 4" air tube to outside cold 60mph air, Rapid Rising fuel regulator, Riva...

spraying it doesn't work unless you're only wanting to do drag race things. problem is it has an impeller and not a transmission. If your engine is running 8k or so on top now, when you hit the spray the rpms will go crazy along with the engine. If you tune the impeller to handle the spray it...

Needs new wear ring or impeller, maybe both. replace with stainless and not the OEM plastic one. my boat will do a wheely out of the hole with stainless and Solas ConcordeR impeller.

Portable fish finder with suction cup transducer mount to hull. Includes wireless sonar unit that can be cast with fishing pole to view areas away from the boat. Good for boat or PWC. $90. I bought a Garmin Echomap Plus 93SV that i'm installing in 150 Speedster, so good deal for someone. Only...

As I mentioned, I have a Hummingbird Piranha portable fish finder that works on it's own batteries and the transducer fastens to the hull with suction cup. It also has a sonar unit that you can cast with fishing pole to areas to view with no wires, etc. and don't have to drive boat over that...

Thanks, I was going thru the area where fuse panel is under front hood as you can get your hand back to the area you located the finder, but going thru the control panel makes sense. Did you consider using bolts with nuts vs the screws? Since the 93sv is 9" I worry about screws pulling out of...

Good job. I have a 150 w/lots of performance mods and putting a Garmin Echomap plus 83SV finder on it. Unfortunately, the side view and down view units won't work in hull. So i'm using a pole mounted transducer that mounts on the forward cleat and has the cleanest water available for the boat...

where did you mount the transducer? have a 2009 speedster 150 and just bought new Garmin echomap 93sv that has a transom mount-cv52. as you know, the transom area on these boats doesn't give you many options. and a real issue to get the cable inside the hull without drilling holes, which I...

will in hull work with Garmin 93SV that uses side view as well as down view?

I use a suckon cup mount for transducer so you can get side views instead of only below boat views and angle is adjustable. Also has a small cork looking transducer you put on fishing line and can cast to areas you want to see . . . no wires and can even attach fishing line to bottom and see...

real cold air intake.

also, the Poppy is the only one that allows you to leave it on when traveling, which is good.