Recent content by Roachie33

The last time run for a length of time was the last week in Sept, but I have started a few times in my driveway to test compression and for other issues. It was rebuilt in 2012 so I wonder if maybe some new rings would do the trick. Does the whole engine have to come out to do rings? I also...

I have a 2001 seedo gtx di with 120 psi in cylinder closest to front and 90psi in cylinder closet to rear. I tested several times same or similar result. I added a little SAE 30 to both heads through plug opening and both cylnders tested at 130psi. I waited approx 2 hours and retested and...

New soldiod installed, cleaned rave valves. Still 120 and 95. I just put a little SAE 30 in each cylinder and retested. 130 and 130Psi. About 2 hours later 125 and 120Psi. Is this normal?

Just received the rave valve solenoid. I am going to install tomorrow. While waiting I decided to do a compression test. Close to the end of last season it was 120psi in both cylinders. Yesterday I got 120 in the one closest to the front and I got all different readings from the one closest...

Earlier on you mentioned the solenoid cycling though 2 twice and when I was out I heard it clicking twice after turning it off. I just ordered a Rave solenoid. I will replace the hoses as well. Thanks for the info.

So it seemed great in my driveway. Test twice in driveway before rave change and it jerked both times. Changed the rave unit out Ian's tested 2 times up to 7000 rpms and no jerk. I put it back on the lake this morning and it jerked. Your thoughts. Maybe valve not opening correcting? Rpms...

BINGO.... So I took the air nipple off the rave housing I replaced last year and fixed the original housing. There was a crack in hose that I cut off as well. Put it back together and no jerking up to 7000'rpms. THANK YOU

Not sure what that would should like. Does this sound like a rave valve issue?

When I cleaned the rave valves is also change the housing because the nipple the house was connect to was broke.

I cleaned them last year at the end of season.

That is correct

It decreases

Ok so i finally performed the pressure test and it maintained 107 psi. I got it up over 6000 rpms and was all good. So pressure is good, battery is good, spark plugs are new, regulator is new and OME and it test good. Still jerking.

Great thanks

Thanks. I found the set up and just started ordering the parts. If I get 107 psi should I take it out for a ride and see if the pressure holds when jerking? Should I replace the inline fuel filter? I read a lot of post that indicated the WIX 3095 is a good replacement and a good value? Just...