Recent content by protrac231

I know this is an old post and that you sold your Speedster 200, but I had a question about your second battery location. I’m trying to figure out where to mount mine.

Where can i get this kit at?

I think you should be ok. I have Polk Audio MM651 speakers installed, and if you drill new ones they will be close, but should work out. At least mine did. I agree with Foster, take a picture and we can help better:cheers::cheers:

Hello all. Im looking for a replacement rear wing and Sun deck pad for my 2002 Challenger 1800. If anyone has a lead on one, or knows were i could pick one up less than buying from SeaDoo it would really help.:cheers: Patrick

Im using a Clarion APX490M, and it works flawlessly. I just purchased a second amp to power just two new Polk subs i bought. I need to build a sealed box for them, so it will be a little while before i get them installed. Its tricky trying to get the subs to fit in a spot and make a box that...

Darthspeed, I am going to take photos first thing tomorrow morning. I just finally finished the setup this afternoon. As you said, i did adjust the gain on the amp to match the channel outputs. It is really loud for sure. I was wondering, you used two of the clarion amps, what did you...

Hey Fellas Hey guys, im just about done with my setup too. I used mostly the ideas from Darth speed. My question is, im using Polk audio mm651's and they have a passive crossover. Measuring the impediance i get a true 2.3ohms. With that siad, wiring the front speakers, i cannot run the left...

Amps Need for speed. You can just carve out an area for the speakers in the foam. I did that and it worked out great. What i was concerned about was putting the amps in the back were the gas tank is, with all of the fumes. I would be afraid that a possible explosion due to a spark or...