Recent content by mjs

Have you tried D and A cycle in Macon? They work on jet ski and jet boats also

measure the width of your alternator pulley or order the one on ebay gazzaskirepair posted

With the measurements, you won't need a part number. They should be about to find 1 with that info. Once again it will still be a trial and error with several belts to get the right one. The belt needs to ride flush with the top of the pulley, not raised out of the pulley or on the bottom.

If you have a piece of the belt to check the width and pitch then get a rough measurement with a string for the length, you should be able to find one at an auto/marine parts store. You may have to get 2 or 3 close to it to find the right one. While your at it, check for wear on your pulleys...

If the rivets where like mine, I couldn't find replacements that were long enough. So I used molly screws. It was still a pain.

If they are anything like my seats on my Islandia, the only seat without a storage compartment under it was the one on the engine cover. It was held in place with pop rivets. Or it could be like the backs, with nuts and a fender washer.

I'm not sure what your alternator output is but my 2001 Islandia has the same motor, 240 EFI gen 1, and it has 6 speakers. I recently replace it with an up grade, blue tooth ect along with new speakers with led lights. I haven't seen any problems.

Just replaced them in my Seadoo boat. The old ones looked good but the would bleed on you every time I walked on the. A little bit of a pain to get the old ones out but really easy putting in the new ones.

Do you have a part number and suppliler for the air temp sensor? This is the one on the port side?

Check your local hardware, Lowes, Home Depot in their specialty bolts, screw part section. I'm sure you can find a rubber grommet that will work.

I finally got all the seats off. I did have to remove the drawer insert under the sink to remove the 2 back pad on both sides of the sink. There is a strap on both sides that must be removed. To access the straps, remove 1 of the cup holders and remove the black cover, 4 screws. It helps to...

I like the bow filler. I assume you're setting this up for a weekend use. Only question I have is were will the bow cushion go when it's not in use? I'm thinking it could be in sections and put in the ski locker.

I'm in the process of re-upholstering my seats on my 2001 Islandia. I found info on how to get the back cushions off from both sides of the sink. I was already working that issue, but I was hoping there was an easier way. Looks like there isn't. My last seat is the one on the hinged cover over...

I was not aware of the pee-hole when I bought my boat this month. I remembered not seeing any water coming out of it but thought nothing about it until I reviewed some of threads on here. I got worried and started checking hoses, running temps and was going to go into the pump until I found a...

I have had a boat of some type all my life and almost all of our vacation/off time involves the water. This is my first Seadoo and specifically a jet boat. I wanted a new to me deck boat for the family. The wife loved the Islandia platform once we looked one. Then is was just finding the right...