Good point. I’m not sure I tried that. I’ll do that when I get home in a bit thank you. And I replaced half of that gray hose because I wanted to see if my hose barbs were causing too much restriction. But once I saw the nipple that the grey hose was on from the carb they were the same size
I have the digital multi function readout. Not sure if it has water temp I’ll check when I get home. I just know last year the analog gauge was intermittent I’m not so sure about the digital. But yesterday I had it running on the trailer and no matter how much I spun the paddle wheel neither...
I tried to remove the 6 screws from the paddle wheel assembly but 2 are stripped. Then I tried to remove the large plate underneath the hull which it’s attached too but it wouldn’t come off. Maybe it’s glued as well as bolted? Just trying to get everything working on this machine and it’s...
01 951 the paddle wheel is still fully intact. Neither the analog or digital speedometer Work. Sometimes randomly it will start working. I know that sometimes the paddle wheels break off but that isn’t the case. And it’s odd that both don’t work. How can I test them with a multimeter?
Pulled the carbs off and removed the thin grey line from the carb to the pump and the small brass restrictor is in there and I can blow through it. Not sure where this check valve ball is but honestly I feel the pump is working fine. Some of the fuel line clamps were not that tight and seemed...
I’m having a hard time finding the restricted part in a diagram. I remember having a hard time finding it before. Could you point me in the right direction please? Also don’t see the hose I cut with a price listed so it’s not available. I guess I’ll bring it to the dealer and hope they have...
Lol yes you did. I didn’t replace those hoses I just cut them and had to put a barb connector in between them because I couldn’t find line that size. Didn’t know if the barb connection was the issue. I’ll report back after I pull the carbs and check for that fitting.
revisiting this thread from last year. I recall fuel spraying out really good while looking with a mirror. There is a thin grey hose that connects both carbs that I cut in order to separate them when I rebuilt them. I then used plastic hose barbs in order to connect them together again. I...
I plan on it but I don’t think I’d blow the engine by not replacing it. It’s as simple as opening the front and checking the tank level with your eye. Who needs technology?!?!
Guessing bad sending unit. I looked at a parts schematic and couldn’t figure out which part to order. Can anyone point me in the right direction or should I buy a used one off of eBay?
Btw it’s a 951