When the PwC is under medium to high throttle it reduces revs for a second and feels like it’s dragging. At first I thought it was the intercooler failing and water getting into the inlet however having inspected it it looks fine. I’m now thinking it might be the impeller, any suggestions before...
It was user error with the can-doo pro software.
I didn’t follow instructions and it locked the fuel pump at the ECU.
In case anyone else does it here is the fix
Go to config tab, enter advanced passcode 1927, and hit submit. Then do normal key procedure to make ecu save
Looks like I’m going to have to try replacement ECU
Tested the new tops sensor and the continuity between the sensor and pin B9 on the ECU, that was fine, checked out the DESS post that can also apparently prevent the ECU triggering Earth to the pump, that was fine, so I’m now down to trying a...
So an update
I’ve checked cleaned and reattached all three small grounds on the block and used dielectric grease on them,
I’ve checked the continuity between Pin B 29 and the pump -ve and that is fine so that cable is not broken. I’ve dielectrically lubricated both A and B connectors into the...
So bit of an update….
I’ve taken everything to pieces and it was a faulty earth to the pump I’ve re-assembled everything and grounded out the Earth wire to the pump which now means that the fuel pump kicks in when the key is attached and the PWC runs. However, it’s now throwing error P0231 which...
I had an issue where the fuel pump wasn’t starting when the key was placed on the DESS post. Took the fuel pump out and diagnosed it to be a bad Earth to the fuel pump. I’ve checked the three earth points at the front of the block, they seem fine, is the fuel pump earth somewhere else?
Many...
Unfortunately the rear seat cushion at the front of my Sea-Doo speedster 160 1988 went overboard yesterday and sank.
Does anyone know where I could get one please?
The boat is red
Regards
John
Unfortunately over winter my starboard rear electrical box melted !
Does anybody know where I can get or have an assembly for sale please?
Regards
John
I ran my 2008 rxtx aground at idle speed on sand and silt. Before I realised what had happened I revved the engine. Got off afloat and seemed to run ok. Seems to flush ok
Wondering if there is anything that I should check?